1
0
mirror of https://git.openwrt.org/openwrt/openwrt.git synced 2024-10-20 22:48:10 +02:00
openwrt/target/linux/ramips/mt7620/config-5.4

194 lines
4.9 KiB
Groff
Raw Normal View History

CONFIG_AR8216_PHY=y
CONFIG_ARCH_32BIT_OFF_T=y
CONFIG_ARCH_CLOCKSOURCE_DATA=y
CONFIG_ARCH_HIBERNATION_POSSIBLE=y
CONFIG_ARCH_MMAP_RND_BITS_MAX=15
CONFIG_ARCH_MMAP_RND_COMPAT_BITS_MAX=15
CONFIG_ARCH_SUSPEND_POSSIBLE=y
CONFIG_AT803X_PHY=y
CONFIG_BLK_MQ_PCI=y
CONFIG_CEVT_R4K=y
CONFIG_CEVT_SYSTICK_QUIRK=y
CONFIG_CLKDEV_LOOKUP=y
CONFIG_CLKEVT_RT3352=y
CONFIG_CLKSRC_MMIO=y
CONFIG_CLONE_BACKWARDS=y
CONFIG_CMDLINE="rootfstype=squashfs,jffs2"
CONFIG_CMDLINE_BOOL=y
# CONFIG_CMDLINE_OVERRIDE is not set
CONFIG_COMPAT_32BIT_TIME=y
CONFIG_CPU_GENERIC_DUMP_TLB=y
CONFIG_CPU_HAS_LOAD_STORE_LR=y
CONFIG_CPU_HAS_PREFETCH=y
CONFIG_CPU_HAS_RIXI=y
CONFIG_CPU_HAS_SYNC=y
CONFIG_CPU_LITTLE_ENDIAN=y
CONFIG_CPU_MIPS32=y
# CONFIG_CPU_MIPS32_R1 is not set
CONFIG_CPU_MIPS32_R2=y
CONFIG_CPU_MIPSR2=y
CONFIG_CPU_MIPSR2_IRQ_VI=y
CONFIG_CPU_NEEDS_NO_SMARTMIPS_OR_MICROMIPS=y
CONFIG_CPU_R4K_CACHE_TLB=y
CONFIG_CPU_SUPPORTS_32BIT_KERNEL=y
CONFIG_CPU_SUPPORTS_HIGHMEM=y
CONFIG_CPU_SUPPORTS_MSA=y
CONFIG_CRYPTO_LIB_POLY1305_RSIZE=2
CONFIG_CRYPTO_RNG2=y
CONFIG_CSRC_R4K=y
CONFIG_DEBUG_PINCTRL=y
CONFIG_DMA_NONCOHERENT=y
CONFIG_DMA_NONCOHERENT_CACHE_SYNC=y
# CONFIG_DTB_MT7620A_EVAL is not set
# CONFIG_DTB_OMEGA2P is not set
CONFIG_DTB_RT_NONE=y
# CONFIG_DTB_VOCORE2 is not set
CONFIG_DTC=y
CONFIG_EARLY_PRINTK=y
CONFIG_ETHERNET_PACKET_MANGLE=y
CONFIG_FIXED_PHY=y
CONFIG_FW_LOADER_PAGED_BUF=y
CONFIG_GENERIC_ATOMIC64=y
CONFIG_GENERIC_CLOCKEVENTS=y
CONFIG_GENERIC_CMOS_UPDATE=y
CONFIG_GENERIC_CPU_AUTOPROBE=y
CONFIG_GENERIC_GETTIMEOFDAY=y
CONFIG_GENERIC_IOMAP=y
CONFIG_GENERIC_IRQ_CHIP=y
CONFIG_GENERIC_IRQ_EFFECTIVE_AFF_MASK=y
CONFIG_GENERIC_IRQ_SHOW=y
CONFIG_GENERIC_LIB_ASHLDI3=y
CONFIG_GENERIC_LIB_ASHRDI3=y
CONFIG_GENERIC_LIB_CMPDI2=y
CONFIG_GENERIC_LIB_LSHRDI3=y
CONFIG_GENERIC_LIB_UCMPDI2=y
CONFIG_GENERIC_PCI_IOMAP=y
CONFIG_GENERIC_PHY=y
CONFIG_GENERIC_PINCONF=y
CONFIG_GENERIC_SCHED_CLOCK=y
CONFIG_GENERIC_SMP_IDLE_THREAD=y
CONFIG_GENERIC_TIME_VSYSCALL=y
CONFIG_GPIOLIB=y
# CONFIG_GPIO_MT7621 is not set
CONFIG_GPIO_RALINK=y
CONFIG_HANDLE_DOMAIN_IRQ=y
CONFIG_HARDWARE_WATCHPOINTS=y
CONFIG_HAS_DMA=y
CONFIG_HAS_IOMEM=y
CONFIG_HAS_IOPORT_MAP=y
CONFIG_HZ_PERIODIC=y
CONFIG_ICPLUS_PHY=y
CONFIG_INITRAMFS_SOURCE=""
CONFIG_IRQCHIP=y
CONFIG_IRQ_DOMAIN=y
CONFIG_IRQ_FORCED_THREADING=y
CONFIG_IRQ_INTC=y
CONFIG_IRQ_MIPS_CPU=y
CONFIG_IRQ_WORK=y
CONFIG_LIBFDT=y
CONFIG_LOCK_DEBUGGING_SUPPORT=y
CONFIG_MARVELL_PHY=y
CONFIG_MDIO_BUS=y
CONFIG_MDIO_DEVICE=y
CONFIG_MEMFD_CREATE=y
CONFIG_MFD_SYSCON=y
CONFIG_MIGRATION=y
CONFIG_MIPS=y
CONFIG_MIPS_ASID_BITS=8
CONFIG_MIPS_ASID_SHIFT=0
CONFIG_MIPS_CBPF_JIT=y
CONFIG_MIPS_CLOCK_VSYSCALL=y
# CONFIG_MIPS_CMDLINE_BUILTIN_EXTEND is not set
# CONFIG_MIPS_CMDLINE_DTB_EXTEND is not set
# CONFIG_MIPS_CMDLINE_FROM_BOOTLOADER is not set
CONFIG_MIPS_CMDLINE_FROM_DTB=y
# CONFIG_MIPS_ELF_APPENDED_DTB is not set
CONFIG_MIPS_L1_CACHE_SHIFT=5
# CONFIG_MIPS_NO_APPENDED_DTB is not set
CONFIG_MIPS_RAW_APPENDED_DTB=y
CONFIG_MIPS_SPRAM=y
CONFIG_MODULES_USE_ELF_REL=y
# CONFIG_MT7621_WDT is not set
# CONFIG_MTD_CFI_INTELEXT is not set
CONFIG_MTD_CMDLINE_PARTS=y
CONFIG_MTD_PHYSMAP=y
CONFIG_MTD_SPI_NOR=y
CONFIG_MTD_SPI_NOR_USE_4K_SECTORS=y
CONFIG_MTD_SPI_NOR_USE_4K_SECTORS_LIMIT=16384
CONFIG_MTD_SPLIT_JIMAGE_FW=y
CONFIG_MTD_SPLIT_SEAMA_FW=y
CONFIG_MTD_SPLIT_TPLINK_FW=y
CONFIG_MTD_SPLIT_UIMAGE_FW=y
ramips: add support for HooToo HT-TM05 The HooToo HT-TM05 is a battery powered router, with an Ethernet and USB port. Vendor U-Boot limited to 1.5 MB kernel size, so use lzma loader (loader-okli). Specifications: SOC: MediaTek MT7620N BATTERY: 10400mAh WLAN: 802.11bgn LAN: 1x 10/100 Mbps Ethernet USB: 1x USB 2.0 (Type-A) RAM: 64 MB FLASH: GigaDevice GD25Q64, Serial 8 MB Flash, clocked at 50 MHz Flash itself specified to 80 MHz, but speed limited by mt7620 SPI fast-read enabled (m25p) LED: Status LED (blue after boot, green with WiFi traffic 4 leds to indicate power level of the battery (unable to control) INPUT: Power, reset button MAC assignment based on vendor firmware: 2.4 GHz *:b4 (factory 0x04) LAN/label *:b4 (factory 0x28) WAN *:b5 (factory 0x2e) Tested and working: - Ethernet - 2.4 GHz WiFi (Correct MAC-address) - Installation from TFTP (recovery) - OpenWRT sysupgrade (Preserving and non-preserving), through the usual ways: command line and LuCI - LEDs (except as noted above) - Button (reset) - I2C, which is needed for reading battery charge status and level - U-Boot environment / variables (from U-Boot, and OpenWrt) Installation: - Download the needed OpenWrt install files, place them in the root of a clean TFTP server running on your computer. Rename the files as, - ramips-mt7620-hootoo_tm05-squashfs-kernel.bin => kernel - ramips-mt7620-hootoo_tm05-squashfs-rootfs.bin => rootfs - Plug the router into your computer via Ethernet - Set your computer to use 10.10.10.254 as its IP address - With your router shut down, hold down the power button until the first white LED lights up. - Push and hold the reset button and release the power button. Continue holding the reset button for 30 seconds or until it begins searching for files on your TFTP server, whichever comes first. - The router (10.10.10.128) will look for your computer at 10.10.10.254 and install the two files. Once it has finished installation, it will automatically reboot and start up OpenWrt. - Set your computer to use DHCP for its IP address Notes: - U-Boot environment can be modified, u-boot-env is preserved on initial install or sysupgrade - mtd-concat functionality is included, to leave a "hole" for u-boot-env, combining the OEM kernel and rootfs partitions I would like to thank @mpratt14 and @xabolcs for their help getting the lzma loader to work! Signed-off-by: Russell Morris <rmorris@rkmorris.us> [drop changes in image/Makefile, fix indent and PKG_RELEASE in uboot-envtools, fix LOADER_FLASH_OFFS, minor commit message facelift, add COMPILE to Device/Default] Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
2019-12-25 01:38:36 +01:00
CONFIG_MTD_VIRT_CONCAT=y
CONFIG_NEED_DMA_MAP_STATE=y
CONFIG_NEED_PER_CPU_KM=y
CONFIG_NET_RALINK_GSW_MT7620=y
CONFIG_NET_RALINK_MDIO=y
CONFIG_NET_RALINK_MDIO_MT7620=y
CONFIG_NET_RALINK_MT7620=y
# CONFIG_NET_RALINK_RT3050 is not set
CONFIG_NET_RALINK_SOC=y
# CONFIG_NET_VENDOR_MEDIATEK is not set
CONFIG_NET_VENDOR_RALINK=y
CONFIG_NO_GENERIC_PCI_IOPORT_MAP=y
CONFIG_OF=y
CONFIG_OF_ADDRESS=y
CONFIG_OF_EARLY_FLATTREE=y
CONFIG_OF_FLATTREE=y
CONFIG_OF_GPIO=y
CONFIG_OF_IRQ=y
CONFIG_OF_KOBJ=y
CONFIG_OF_MDIO=y
CONFIG_OF_NET=y
CONFIG_PCI=y
CONFIG_PCI_DOMAINS=y
CONFIG_PCI_DRIVERS_LEGACY=y
# CONFIG_PCI_MT7621 is not set
# CONFIG_PCI_MT7621_PHY is not set
CONFIG_PERF_USE_VMALLOC=y
CONFIG_PGTABLE_LEVELS=2
CONFIG_PHYLIB=y
CONFIG_PHY_RALINK_USB=y
CONFIG_PINCTRL=y
CONFIG_PINCTRL_RT2880=y
# CONFIG_PINCTRL_SINGLE is not set
CONFIG_RALINK=y
CONFIG_RALINK_WDT=y
CONFIG_REGMAP=y
CONFIG_REGMAP_MMIO=y
CONFIG_RESET_CONTROLLER=y
CONFIG_SERIAL_8250_RT288X=y
CONFIG_SERIAL_MCTRL_GPIO=y
CONFIG_SERIAL_OF_PLATFORM=y
CONFIG_SOC_MT7620=y
# CONFIG_SOC_MT7621 is not set
# CONFIG_SOC_RT288X is not set
# CONFIG_SOC_RT305X is not set
# CONFIG_SOC_RT3883 is not set
CONFIG_SPI=y
CONFIG_SPI_MASTER=y
CONFIG_SPI_MEM=y
# CONFIG_SPI_MT7621 is not set
CONFIG_SPI_RT2880=y
CONFIG_SRCU=y
CONFIG_SWCONFIG=y
CONFIG_SWCONFIG_LEDS=y
CONFIG_SWPHY=y
CONFIG_SYSCTL_EXCEPTION_TRACE=y
CONFIG_SYS_HAS_CPU_MIPS32_R1=y
CONFIG_SYS_HAS_CPU_MIPS32_R2=y
CONFIG_SYS_HAS_EARLY_PRINTK=y
CONFIG_SYS_SUPPORTS_32BIT_KERNEL=y
CONFIG_SYS_SUPPORTS_ARBIT_HZ=y
CONFIG_SYS_SUPPORTS_LITTLE_ENDIAN=y
CONFIG_SYS_SUPPORTS_MIPS16=y
CONFIG_SYS_SUPPORTS_ZBOOT=y
CONFIG_TARGET_ISA_REV=2
CONFIG_TICK_CPU_ACCOUNTING=y
CONFIG_TIMER_OF=y
CONFIG_TIMER_PROBE=y
CONFIG_TINY_SRCU=y
CONFIG_USB_SUPPORT=y
CONFIG_USE_OF=y
CONFIG_WATCHDOG_CORE=y