180a33b372
* Increase idle timeout to 24 hours, and set motors to turn off. * Set electronics fan min PWM and blip time because my fans are sluggish. * Extruder drive current adjustments based on PA trials to avoid skipping steps. * Preheat scripts used the wrong fan control command. And fix some temps. * Make toolhead heater selection sticky by writing out /sys/restore_tool_heater.g. * Reduce default PLA print temp. * Make firmware retraction profile selection sticky by writing out to /sys/restore_retraction.g. Make separate profiles for V6 and Volcano. * Filament sensors need to be _turned on_. * Release notes. * Pulling in comments from public branch. * Adding named heatbreak thermistor. * Increasing instantaneous drive parameters on XY * Turn off extruder drive in print_end.g * Tweaking mswitch_xy.g position. * Missed configuration on the heatbreak thermistor. * Changed origin coordinates to be at bed center. * Deselect and re-select tool across pause. (Set to standby temp.) * Set bed standby temps in preheat scripts. * Add a script for calibrating the mswitch. * Reduce instantaneous XY drive parameters. * Increasing pressure advance values for Volcano. * Full-speed chamber fan on print end. * Adding another toolhead profile. * Adding a coarse leveling script for when the gantry is too far out to be corrected by the default dive height. * Move toolhead thermistor parameters to the heating/toolhead_* scripts, because they change when you swap toolheads. * README.txt * README.txt * FSR Z endstop. * Don't disable heaters during Z probing. Turns out it's actually not needed and the thermal delta actually messes up the readings. * README.txt * Moving daveidmx config from DuetWifi folder to Duet folder. |
||
|---|---|---|
| .. | ||
| daveidmx | ||
| Duet/Configs | ||