Update Voron2_Spider_Config.cfg

a few small cleanups to Spider printer.cfg

firmware/klipper_configurations/Spider/Voron2_Spider_Config.cfg

@@ -34,7 +34,7 @@ square_corner_velocity: 5.0
 [stepper_x]
 ##	Connected to X-MOT (B Motor)
 step_pin: PE11
-dir_pin: !PE10
+dir_pin: PE10
 enable_pin: !PE9
 rotation_distance: 40
 microsteps: 16
@@ -73,7 +73,7 @@ stealthchop_threshold: 0
 [stepper_y]
 ##	Connected to Y-MOT (A Motor)
 step_pin: PD8
-dir_pin: !PB12
+dir_pin: PB12
 enable_pin: !PD9
 rotation_distance: 40
 microsteps: 16
@@ -116,7 +116,7 @@ stealthchop_threshold: 0
 ## Z0 Stepper - Front Left
 [stepper_z]
 step_pin: PD14
-dir_pin: !PD13
+dir_pin: PD13
 enable_pin: !PD15
 rotation_distance: 40
 gear_ratio: 80:16
@@ -148,7 +148,6 @@ homing_retract_dist: 3
 ##	Make sure to update below for your relevant driver (2208 or 2209)
 [tmc2209 stepper_z]
 uart_pin: PD10
-uart_address: 0
 interpolate: True
 run_current: 0.8
 hold_current: 0.8
@@ -159,7 +158,7 @@ stealthchop_threshold: 0
 ##	Z1 Stepper - Rear Left
 [stepper_z1]
 step_pin: PE6
-dir_pin: PC13
+dir_pin: !PC13
 enable_pin: !PE5
 rotation_distance: 40
 gear_ratio: 80:16
@@ -178,7 +177,7 @@ stealthchop_threshold: 0
 ##	Z2 Stepper - Rear Right
 [stepper_z2]
 step_pin: PE2
-dir_pin: !PE4
+dir_pin: PE4
 enable_pin: !PE3
 rotation_distance: 40
 gear_ratio: 80:16
@@ -197,7 +196,7 @@ stealthchop_threshold: 0
 ##	Z3 Stepper - Front Right
 [stepper_z3]
 step_pin: PD12
-dir_pin: PC4
+dir_pin: !PC4
 enable_pin: !PE8
 rotation_distance: 40
 gear_ratio: 80:16
@@ -218,7 +217,7 @@ stealthchop_threshold: 0
 ##	In E0-MOT Position
 [extruder]
 step_pin: PD5
-dir_pin: !PD6
+dir_pin: PD6
 enable_pin: !PD4
 
 ##	Update value below when you perform extruder calibration
@@ -502,7 +501,7 @@ gcode:
     G0  X125 Y250 F3600            ; park nozzle at rear
     BED_MESH_CLEAR
     
-## 	Thermistor Types
+## 	Common Temperature Sensors
 ##   "EPCOS 100K B57560G104F"
 ##   "ATC Semitec 104GT-2"
 ##   "NTC 100K beta 3950"