OSHW-DEIMOS/SOFTWARE/A64-TERES/linux-a64/drivers/net/wireless/rtl8189fs/include/autoconf.h
Dimitar Gamishev f9b0e7a283 linux
2017-10-13 14:07:04 +03:00

250 lines
6.3 KiB
C

/******************************************************************************
*
* Copyright(c) 2007 - 2014 Realtek Corporation. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of version 2 of the GNU General Public License as
* published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful, but WITHOUT
* ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
* FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
* more details.
*
* You should have received a copy of the GNU General Public License along with
* this program; if not, write to the Free Software Foundation, Inc.,
* 51 Franklin Street, Fifth Floor, Boston, MA 02110, USA
*
*
******************************************************************************/
/*
* Public General Config
*/
#define AUTOCONF_INCLUDED
#define RTL871X_MODULE_NAME "8189FS"
#define DRV_NAME "rtl8189fs"
#ifndef CONFIG_RTL8188F
#define CONFIG_RTL8188F
#endif
#define CONFIG_SDIO_HCI
#define PLATFORM_LINUX
/*
* Wi-Fi Functions Config
*/
#define CONFIG_80211N_HT
#define CONFIG_RECV_REORDERING_CTRL
//#define CONFIG_IOCTL_CFG80211 // Set from Makefile
#ifdef CONFIG_IOCTL_CFG80211
/*
* Indecate new sta asoc through cfg80211_new_sta
* If kernel version >= 3.2 or
* version < 3.2 but already apply cfg80211 patch,
* RTW_USE_CFG80211_STA_EVENT must be defiend!
*/
//#define RTW_USE_CFG80211_STA_EVENT /* Indecate new sta asoc through cfg80211_new_sta */
#ifndef CONFIG_PLATFORM_INTEL_BYT
#define CONFIG_CFG80211_FORCE_COMPATIBLE_2_6_37_UNDER
#endif //!CONFIG_PLATFORM_INTEL_BYT
//#define CONFIG_DEBUG_CFG80211
#define CONFIG_SET_SCAN_DENY_TIMER
#endif
#define CONFIG_AP_MODE
#ifdef CONFIG_AP_MODE
#define CONFIG_NATIVEAP_MLME
#ifndef CONFIG_NATIVEAP_MLME
#define CONFIG_HOSTAPD_MLME
#endif
//#define CONFIG_FIND_BEST_CHANNEL
#define CONFIG_TX_MCAST2UNI // Support IP multicast->unicast
#endif
#define CONFIG_P2P
#ifdef CONFIG_P2P
//Added by Albert 20110812
//The CONFIG_WFD is for supporting the Wi-Fi display
#define CONFIG_WFD
#define CONFIG_P2P_REMOVE_GROUP_INFO
//#define CONFIG_DBG_P2P
#define CONFIG_P2P_PS
//#define CONFIG_P2P_IPS
#define CONFIG_P2P_OP_CHK_SOCIAL_CH
#define CONFIG_CFG80211_ONECHANNEL_UNDER_CONCURRENT //replace CONFIG_P2P_CHK_INVITE_CH_LIST flag
#define CONFIG_P2P_INVITE_IOT
#endif
// Added by Kurt 20110511
#ifdef CONFIG_TDLS
#define CONFIG_TDLS_DRIVER_SETUP
// #ifndef CONFIG_WFD
// #define CONFIG_WFD
// #endif
// #define CONFIG_TDLS_AUTOSETUP
#define CONFIG_TDLS_AUTOCHECKALIVE
#define CONFIG_TDLS_CH_SW /* Enable "CONFIG_TDLS_CH_SW" by default, however limit it to only work in wifi logo test mode but not in normal mode currently */
#endif
//#define CONFIG_CONCURRENT_MODE // Set from Makefile
#ifdef CONFIG_CONCURRENT_MODE
//#define CONFIG_HWPORT_SWAP // Port0->Sec , Port1 -> Pri
#define CONFIG_RUNTIME_PORT_SWITCH
#ifndef CONFIG_RUNTIME_PORT_SWITCH
#define CONFIG_TSF_RESET_OFFLOAD // For 2 PORT TSF SYNC.
#endif
//#define DBG_RUNTIME_PORT_SWITCH
#define CONFIG_SCAN_BACKOP
#endif // CONFIG_CONCURRENT_MODE
#define CONFIG_LAYER2_ROAMING
#define CONFIG_LAYER2_ROAMING_RESUME
//#define CONFIG_80211D
/*
* Hareware/Firmware Related Config
*/
//#define CONFIG_BT_COEXIST // Set from Makefile
//#define CONFIG_ANTENNA_DIVERSITY // Set from Makefile
//#define SUPPORT_HW_RFOFF_DETECTED
//#define CONFIG_SW_LED
#define CONFIG_XMIT_ACK
#ifdef CONFIG_XMIT_ACK
#define CONFIG_ACTIVE_KEEP_ALIVE_CHECK
#endif
#define CONFIG_C2H_PACKET_EN
#define CONFIG_RF_GAIN_OFFSET
#define DISABLE_BB_RF 0
#define RTW_NOTCH_FILTER 0 /* 0:Disable, 1:Enable, */
/*
* Interface Related Config
*/
#define CONFIG_SDIO_CHK_HCI_RESUME
#define CONFIG_TX_AGGREGATION
#define CONFIG_SDIO_RX_COPY
#define CONFIG_XMIT_THREAD_MODE
#define CONFIG_SDIO_TX_ENABLE_AVAL_INT
/*
* Others
*/
//#define CONFIG_MAC_LOOPBACK_DRIVER
#define CONFIG_SKB_COPY //for amsdu
#define CONFIG_NEW_SIGNAL_STAT_PROCESS
#define CONFIG_EMBEDDED_FWIMG
//#define CONFIG_FILE_FWIMG
#define CONFIG_LONG_DELAY_ISSUE
//#define CONFIG_PATCH_JOIN_WRONG_CHANNEL
#define CONFIG_ATTEMPT_TO_FIX_AP_BEACON_ERROR
/*
* Auto Config Section
*/
#ifdef CONFIG_MAC_LOOPBACK_DRIVER
#undef CONFIG_IOCTL_CFG80211
#undef CONFIG_AP_MODE
#undef CONFIG_NATIVEAP_MLME
#undef CONFIG_POWER_SAVING
#undef CONFIG_BT_COEXIST
#undef CONFIG_ANTENNA_DIVERSITY
#undef SUPPORT_HW_RFOFF_DETECTED
#endif
#ifdef CONFIG_MP_INCLUDED
#define MP_DRIVER 1
#define CONFIG_MP_IWPRIV_SUPPORT
#else // !CONFIG_MP_INCLUDED
#define MP_DRIVER 0
#endif // !CONFIG_MP_INCLUDED
#ifdef CONFIG_POWER_SAVING
#define CONFIG_IPS
#define CONFIG_LPS
#if defined(CONFIG_LPS) && (defined(CONFIG_GSPI_HCI) || defined(CONFIG_SDIO_HCI))
#define CONFIG_LPS_LCLK
#endif
#ifdef CONFIG_LPS
#define CONFIG_CHECK_LEAVE_LPS
#ifndef CONFIG_PLATFORM_INTEL_BYT
#define CONFIG_LPS_SLOW_TRANSITION
#endif
#endif
#ifdef CONFIG_LPS_LCLK
#define CONFIG_DETECT_CPWM_BY_POLLING
#define CONFIG_LPS_RPWM_TIMER
#if defined(CONFIG_LPS_RPWM_TIMER) || defined(CONFIG_DETECT_CPWM_BY_POLLING)
#define LPS_RPWM_WAIT_MS 300
#endif
#define CONFIG_LPS_LCLK_WD_TIMER /* Watch Dog timer in LPS LCLK */
#endif
#ifdef CONFIG_IPS
#define CONFIG_IPS_CHECK_IN_WD /* Do IPS Check in WatchDog */
//#define CONFIG_SWLPS_IN_IPS /* Do SW LPS flow when entering and leaving IPS */
//#define CONFIG_FWLPS_IN_IPS /* issue H2C command to let FW do LPS when entering IPS */
#endif
#endif /* CONFIG_POWER_SAVING */
#define BT_30_SUPPORT 0
#ifdef CONFIG_WOWLAN
//#define CONFIG_GTK_OL
#define CONFIG_ARP_KEEP_ALIVE
#endif // CONFIG_WOWLAN
#ifdef CONFIG_GPIO_WAKEUP
#ifndef WAKEUP_GPIO_IDX
#define WAKEUP_GPIO_IDX 0
#endif
#endif
#ifdef CONFIG_ANTENNA_DIVERSITY
#define CONFIG_HW_ANTENNA_DIVERSITY
#endif
/*
* Debug Related Config
*/
#define CONFIG_DEBUG /* DBG_871X, etc... */
#ifdef CONFIG_DEBUG
#define DBG 1 // for ODM & BTCOEX debug
//#define CONFIG_DEBUG_RTL871X /* RT_TRACE, RT_PRINT_DATA, _func_enter_, _func_exit_ */
#else // !CONFIG_DEBUG
#define DBG 0 // for ODM & BTCOEX debug
#endif // !CONFIG_DEBUG
#define CONFIG_PROC_DEBUG
#define DBG_CONFIG_ERROR_DETECT
//#define DBG_XMIT_BUF
//#define DBG_XMIT_BUF_EXT
//#define DBG_CHECK_FW_PS_STATE
//#define DBG_CHECK_FW_PS_STATE_H2C
//#define CONFIG_FW_C2H_DEBUG